|
Radiantz LED Clusters
THESE ARE THE SAME LIGHTS USED IN MANY OF THE TOP MOTORCYCLE AFTERMARKET TURN SIGNALS BECAUSE OF THEIR BRILLIANCE AND VIEWING ANG
by Radiantz
These wide angle (45 Degree) super bright LEDS are available in the following sizes:
1.00"or 2,54cm Diameter - 16 LEDs, Choice or Red or Amber < 0.1A @ full intensity @ 14VDC
1.25"or 3,17cm Diameter - 25 LEDs, Choice of Red or Amber < 0.125A @ full intensity @ 14VDC
1.85"or 4,7cm Diameter - 48 LEDs, Choice or Red or Amber < 0.3A @ full intensity @ 14VDC
Note: These bulbs are NOT D.O.T. certified.
Tip: For Best results use the same color LEDs as your lens, unless you have a clear lens.
1.25"or 3,17cm Clusters make great replacement for Halogen MR-11 Bulbs - Small Silver Bullets
1.85"or 4,7cm Clusters make great replacement for Halogen MR-16 Bulbs - Large Silver Bullets
Large Silver Bullet with 1.85"or 4,7cm LED Cluster
These LED Clusters are available in three different configurations:
Hardwire version are 3 wire - low, high, ground - can be used as single or dual intensity
1156 are single intensity
1157 are dual intensity
Tip: If you are planning to replace your tail light with LEDs, we suggest that you first check to see if we carry a LED Tail light Retro Kit if not, we suggest that you use the largest LED Cluster that will fit into your turn signal housing.
Tip: If you are planning to replace your turn signals with LEDs, we suggest that you first check to see if we carry a LED Turn Signal Reto Kit if not, we suggest that you use the largest LED Cluster that will fit into your turn signal housing.
Check out the Review at Product Testing Labs
If you have purchased low quality LED in the past you probably found out that they were not as bright as your stock. These LEDs are wide angle, high quality, super bright LEDS. Take a look at the test results from the guys over at web bike world.
http://www.webbikeworld.com/r2/led/led.htm
For maximum visibility use the largest cluster that will fit your housing, we do not recommend using the 1.0"or 2,54cm or the 1.25"3,17cm for tail light applications, the 1.85"or 4,7cm is the recommended choice for tail lights.
Most front motorcycle turn signals are dual intensity, they light up as a low intensity running light at approximately 30% of full brightness and when the turn signal is activated they flash from the running light intensity level (30%) to full brightness (100%).
Eclipze™ LEDs are designed to increase your frontal visibility in four ways. First, the running light intensity is changed from 30% of full brightness to 100% of full brightness making you motorcycle more visible all at times. Secondly, when a turn signal is activated the LEDs flash from 100% to 0% brightness giving more contrast as a turn signal, thus increasing your visibility when you are turning. Next, because Eclipze™ uses 48 high powered wide angle LEDs, they provide more light output than standard incandescent bulbs. Lastly, because LEDs illuminate 1/5 of a second faster than standard incandescent bulbs, this provides greater reaction time for other vehicles when your motorcycle is signaling for a turn, at 65mph this equates to 17 ft of reaction distance.
|
