|
Knight Rider
This light bar contains 12 high power dual intensity LEDs. In running light mode the LEDs sequence from side to side in a "Knight Riderz" sequence. When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released. Both modes, running and brake, have been designed to create the maximum viability. The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface. Simply connect the black wire to any ground wire, the Red wire to your exiting brake light wire and the blue wire to an existing running light power source. Works with any 12VDC system, no load equalizer or resistors required. Dimensions: 4.7" long x .7" wide x .7" high.
Our new LB07 light bar contains 12 high power Single intensity LEDs.
There are three built in strobe patterns that will demand attention from anyone behind your vehicle.
There is a constant strobe pattern, a double beat and a quad beat pattern, check out the video.
When the brake is applied the LED will strobe based on what pattern you have selected.
The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface.
Works with any 12VDC system, no load equalizer or resistors required.
Dimensions: 4.7" long x .7" wide x .7" high.
Available in Red.
This light bar contains 12 high power sequential LEDs.
When your turn signal is activated, the unit will initiate a sequence that corresponds to your turn signal flash.
The unit will work with flashers that flash between 60-120 times per second, standard DOT rate.
The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface.
Simply connect the black wire to any ground wire, the Red wire to your a existing power source and the blue wire to your turn signal.
Works with any 12VDC system.
Dimensions: 4.7" long x .7" wide x .7" high.
Available in Red and Amber.
Works great for auxiliary turn signals, mounts to saddle bags, trike fenders, etc.
A pair of Knight Riderz are required, one for a left turn signal and one for a right turn signal, please enter a quantity of 2 when ordering.
New Longer 21 LED Knight Riderz
This light bar contains 21 high power dual intensity LEDs.
In running light mode the LEDs sequence from side to side in a "Knight Rider" sequence.
When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released.
Both modes, running and brake, have been designed to create the maximum visibility.
The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface.
Simply connect the black wire to any ground wire, the Red wire to your existing brake light wire and the blue wire to an existing running light power source. Works with any 12VDC system, no load equalizer or resistors required.
Dimensions: 7.5" long19cm x .7" wide1,8cm x .7" high1,8cm.
Available in Red or Smoked.
|
